Nothing to do with uC: measuring parasitic draw from car battery


Author Message
Mixtel90

Guru

Joined: 05/10/2019
Location: United Kingdom
Posts: 9328
Posted: 07:31am 16 Aug 2024      

I would suggest following Bleep's advice. Use the highest current range that you can *without* having to swap the meter lead to select a high current range (usually 10A or 20A). Then also link across the meter during the initial boot. Then remove the link. You can then switch the meter range down if necessary.

If you pop meter fuses they can be inconvenient and expensive to replace. :(

Another way, which is very safe, is to simply introduce a 0.1R resistor in the battery lead. Measure the current by measuring the voltage across it. Your meter is safe against all surges then. 1V measured will be 100mA.