Guru
Joined: 05/10/2019
Location: United KingdomPosts: 8756
| Posted: 09:46am 23 Aug 2024 |
Woo!
Only USB host support to go now?
I'm fitting links to isolate the USB pins so that a simple USB breakout can be connected for initial loading of the firmware, Then links can be fitted to connect the pins to the USB hub module. After that you have 4 USB-A sockets on the board.
GP8 & GP9 are connected to a USB-C to TTL adapter via a level shifter. This can be unplugged to allow access to those pins should it be needed. I thought that was probably better at this stage, although I think MOSFETs would be fine eventually. You can get a USB-C to TTL module with 3V3 outputs but I happen to have a couple of these. They also incorporate a 500mA fuse.
I asked about this earlier but I think you missed it (or I missed your answer). Are both COM1 and COM2 still available when GP8 and GP9 are being used for the console?