Guru
Joined: 11/02/2018
Location: AustraliaPosts: 3073
| Posted: 08:18am 10 Jun 2025 |
The bottom section "Data read from EEPROM" should show 4 pages of 32 bytes per line like this from RC19.
Data read from EEPROM
<-ptr A= 0, Page 0, A= 31-><-ptr A= 32, Page 1, A= 63-><-ptr A= 64, Page 2, A= 95-><-ptr A= 96, Page 3, A= 127->
<-ptr A= 128, Page 4, A= 159-><-ptr A= 160, Page 5, A= 191-><-ptr A= 192, Page 6, A= 223-><-ptr A= 224, Page 7, A= 255->
<-ptr A= 256, Page 8, A= 287-><-ptr A= 288, Page 9, A= 319-><-ptr A= 320, Page 10, A= 351-><-ptr A= 352, Page 11, A= 383->
<-ptr A= 384, Page 12, A= 415-><-ptr A= 416, Page 13, A= 447-><-ptr A= 448, Page 14, A= 479-><-ptr A= 480, Page 15, A= 511->
...
<-ptr A= 0, Page 0, A= 31-><-ptr A= 32, Page 1, A= 63-><-ptr A= 64, Page 2, A= 95-><-ptr A= 96, Page 3, A= 127->
<-ptr A= 128, Page 4, A= 159-><-ptr A= 160, Page 5, A= 191-><-ptr A= 192, Page 6, A= 223-><-ptr A= 224, Page 7, A= 255->
<-ptr A= 256, Page 8, A= 287-><-ptr A= 288, Page 9, A= 319-><-ptr A= 320, Page 10, A= 351-><-ptr A= 352, Page 11, A= 383->
<-ptr A= 384, Page 12, A= 415-><-ptr A= 416, Page 13, A= 447-><-ptr A= 448, Page 14, A= 479-><-ptr A= 480, Page 15, A= 511->
...
It looks like you are only getting 52 characters out of 128 per line.
As the EEPROM address pointer stops incrementing at the point where it stops reading the next 128 byte read starts where the last finished but once again stops short so the last half of it doesn't get read. The last page shown is 52 out of 128 that were written.
Edited 2025-06-10 18:38 by phil99