Admin Group
Joined: 31/12/2012
Location: New ZealandPosts: 9867
| Posted: 12:13am 14 Jun 2025 |
I will ensure pot is mid-range first, then do the power check thing.
I have to do a bit more research on Peter's original thread.
I can't remember what the purpose of the little trimmer is, but I am sure it is there for good reason. None of the other boards have it, so perhaps it is specific to the 2350 chip or something - I will go do a bit more reading to find out.
JLC website DID moan that the oscillator and caps were NOT those specifically stated by Raspberry PI Org that you are supposed to use, but I basically ignored it, assuming Peter knows what he's doing with PI boards now, and I have also seen posts from others who have had these boards made, and they obviously start up fine, so....