Guru
Joined: 22/02/2006
Location: AustraliaPosts: 2080
| Posted: 02:38am 17 Apr 2026 |
Ok getting alot closer but getting a buffer full error
so commented out so only the one G-code line was there Stepper initialized - 100KHz timer active
Warning: Soft limits not configured. Use STEPPER LIMITS to set working area.
Hardware limit switches configured
Stepper armed - executing buffered commands
[39] Stepper gc g1 x100 f100
Error : G-code buffer full
Warning: Soft limits not configured. Use STEPPER LIMITS to set working area.
Hardware limit switches configured
Stepper armed - executing buffered commands
[39] Stepper gc g1 x100 f100
Error : G-code buffer full
Now I've taken out the Y axis and gave it a good clean, now found there a dual nut setup for the backlash, now mounting the stepper is a pinch as I'll just put the leadscrew in my lathe and drill a 8mm hole where a couple of grub screws can be used for the drive. Then a simple mount can be made to clamp the stepper.
I sort of figure once I can get the code working may aswell have the stepper under load
and thats one axis sorted for the project.