Regular Member
Joined: 11/01/2020
Location: CanadaPosts: 56
| Posted: 02:39pm 28 Apr 2026 |
Hi Guys,
I just wanted to say thank you to Mick and Lyle for your help.
Based on your suggestions I did a lot of testing and found I had made a very stupid mistake. I had the parameters on the touch command reversed. I did a total reset on the unit, reentered the updated commands and now the touch is working great.
Lyle, I hadn’t seen the “LIST SYSTEM I2C” command before and it was very helpful. I’m going to try getting the RTC working next. It’s a PCF85063 rather than a PCF8563 that is listed in the User Manual. I’ll post something if I get it working.
Again, thanks for your help.
Don