MMBasic ANSI - MMBasic on Mac/Windows/Linux in a terminal

Author	Message
ville56 Guru Joined: 08/06/2022 Location: Austria Posts: 560	Posted: 04:23pm 08 Jun 2026         jvanderberg said   If you follow the Readme instructions for command line tools it should properly program in DIO. If you are using the GUI tool, make sure to set SPI MODE = DIO (not QIO), SPI SPEED = 40MHz. Let me know if that works. - thats exactly what I did set up. - The serial is available over USB, just tested with Annex32 basic. Will try to investigate further. The board is one of the many chinese clones, has 16Mb flash and runs fine with Annex32. Have a different board with 32Mb, will try with that as well.