Guru
Joined: 22/02/2006
Location: AustraliaPosts: 2133
| Posted: 12:28am 03 Jun 2026 |
Ok loaded up V6.02.00 and got this
> option list
PicoMite MMBasic RP2040 V6.02.00
OPTION SYSTEM I2C GP14,GP15
OPTION COLOURCODE ON
OPTION CPUSPEED (KHz) 280000
> C:\Users\Bryan\Documents\MMBasic Code\camera board.bas
Uploading using: 'target port\COM13:115200 s\picomite
Upload started
NEW
>
AUTOSAVE N
Progress: 1/16
Upload completed 1
Saved 261 bytes
>
Time taken: 1279mS
RUN
[5] Camera OPEN GP8, GP10, GP11, GP12, GP13, GP0
Error : Invalid display type
PicoMite MMBasic RP2040 V6.02.00
OPTION SYSTEM I2C GP14,GP15
OPTION COLOURCODE ON
OPTION CPUSPEED (KHz) 280000
> C:\Users\Bryan\Documents\MMBasic Code\camera board.bas
Uploading using: 'target port\COM13:115200 s\picomite
Upload started
NEW
>
AUTOSAVE N
Progress: 1/16
Upload completed 1
Saved 261 bytes
>
Time taken: 1279mS
RUN
[5] Camera OPEN GP8, GP10, GP11, GP12, GP13, GP0
Error : Invalid display type
So I had to fire up my laptop to get V6 and this was the result
RUN
[5] Camera OPEN GP8, GP10, GP11, GP12, GP13, GP0
Error : Invalid display type
> option list
PicoMite MMBasic RP2040 Edition V6.00.02
OPTION SYSTEM I2C GP14,GP15
OPTION COLOURCODE ON
OPTION CPUSPEED (KHz) 280000
[5] Camera OPEN GP8, GP10, GP11, GP12, GP13, GP0
Error : Invalid display type
> option list
PicoMite MMBasic RP2040 Edition V6.00.02
OPTION SYSTEM I2C GP14,GP15
OPTION COLOURCODE ON
OPTION CPUSPEED (KHz) 280000
So I do think it's time to solder some pins on 2040 chip so I can have the LCD and the camera on the same pico.
Now I did have the breadboard powered up and the zero connected to GP14, GP15 doing a I2C check came back with pin not set so this zero piggyback project can go in the bin as I think that is the problem.