Senior Member
Joined: 19/06/2011
Location: AustraliaPosts: 167
| Posted: 09:00am 26 Jun 2011 |
Hi Don
Good idea ... after starting on my 240v remote switch using a real breadboard ( not the PCB type )... I spent a lot of time striping and tinning the ends of the individual wires on the ribbon cable to plug into the breadboard. I realise I could have just used the wires I needed but I did all of them so I could experiment more later.
I thought the wires for Pin 1 to 20 would just come out in order but instead they ended up crossing over one another.
Really need a means of getting these pins out in some order. May I suggest a PCB with the 26pin male PCB connector on one side and a strip of molex pins on the other side which plugs into a real breadboard or a PCB breadboard as well.
cheers
Keith
The more we know, the more we know we don't know !