I/O Board Addressing for Bus Cable

Author	Message
donmck Guru Joined: 09/06/2011 Location: Australia Posts: 1314	Posted: 09:35am 26 Jun 2011         Keith @ said   Hi Don Good idea ... after starting on my 240v remote switch using a real breadboard ( not the PCB type )... I spent a lot of time striping and tinning the ends of the individual wires on the ribbon cable to plug into the breadboard. I realise I could have just used the wires I needed but I did all of them so I could experiment more later. Really need a means of getting these pins out in some order. May I suggest a PCB with the 26pin male PCB connector on one side and a strip of molex pins on the other side which plugs into a real breadboard or a PCB breadboard as well. cheers Keith Prompted by your message Keith, I decided to bring users a little more up to date with a few pictures of where we are heading. http://www.themaximitecomputer.com/maximite-io-board-address ing-for-bus-cable-interfacing/ A lot of ideas have changed as we have kicked ideas around, so much of the text is now out of date. Cheers Don... https://www.dontronics.com