Senior Member
Joined: 15/06/2011
Location: AustraliaPosts: 819
| Posted: 07:45am 28 Jun 2011 |
i am having trouble with the anolog pin`s,..seems i cant hold it a zero ..i am trying to use it as a voltneter atm but have written a short program to disp on the screen ..have a 4.7 k to ground but it still dances around and i need to have a precise measurement...even with the expander board it wont stableize ...also i have to write more in the progrm to reset the voltage reading ever few seconds say between ten and 20 seconds i think the loop statement may do this but i..i am pretty new to basic i did some at school but there was only one computer back then and did not have my own ..until i got a 8bit pc ten meg turbo board which ran dos... thanks to all who reply....
technicians do it with least resistance