Guru
Joined: 22/02/2006
Location: AustraliaPosts: 1396
| Posted: 12:50am 25 Apr 2023 |
G'Day Guy's,
Well had a go this morning and YES I did get the F3 screen lit up so tested one of the axis only to find the board was like hammering and no step movement. Now the E-Stop I have setup on the CNC does show on the linuxCNC screen as off so there is a connection thru the PCI card.
Yesterday where I had to use my mobile in usb tethering mode just to get the net wasn't needed as the ethernet cable going to my shed wifi router just worked
Also made those 2 folders for the starex driver only to find the command failed due to no rule in the folder
Got a few jobs to do on the farm so more play later in the day
Cheers Bryan