Guru
Joined: 22/02/2006
Location: AustraliaPosts: 1371
| Posted: 11:54pm 29 Dec 2014 |
G'day Guy's,
Well finally got around to finishing off the limit switch's so now all 3 axis has limits. I decided to go with just using one limit switch and milled up guides for them in my bridgeport mill.
Here is a pic of the Y axis rail where I used some brass angle iron mounted on some thin gauge steel angle.
Same with the Z axis I just some some ali flat bar.
Now with these elcheapo 3 axis controllers there is connector for using joystick and lcd panels etc. That one below the parallel port is the one I mean
I have looked on the net to try and find the pinouts for that connector with no luck so if anyone has the pinout it would be great.
Regards Bryan