Guru
Joined: 02/12/2009
Location: AustraliaPosts: 2539
| Posted: 07:40pm 03 Jan 2015 |
Hi All
I have used furniture tee nuts for the MDF board when making jigs, they are a threaded spigot that goes through the MDF with a big washer on the bottom, and to stop it spinning there are four spikes that grip into the board. I epoxy them into the board after tightening to set the spikes in place, they also work well on plywood, and do not cause any distortion of the board.
All the best
Bob
Foolin Around