Guru
Joined: 20/06/2011
Location: AustraliaPosts: 2981
| Posted: 01:07pm 04 Jan 2015 |
Hi TZ,
Thank you for your input..
You are correct C2 is incorrectly labelled as C3 I will correct that.
When I designed the schematic I was going to use 10k for the pullup on the MCLR pin, as I had to buy a reel of 0805 4k7 ohm resistors I decided to use 4k7 instead.. Yes I will change that.. Of course either value is fine but consistency should rule.
Re. Your schematic.
I admit my Schematic skills are not all that great, I do not have the flair that some people do in that regard.. with your permission I will add your Schematic to the manual as it does clarify the DIP8 Pins better than mine does. I am not really a fan of the colours but your layout and links look better. I will try to improve my Schematic skills, I have only recently discovered that, with DEX, I can hide unused pins and move the used ones around to group them more appropriately..
PM me your address again and I will send you a slab of NanoMites for your school in appreciation of all of your support for this and other boards.
Kind Regards,
Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<