Guru
Joined: 23/12/2015
Location: United KingdomPosts: 1709
| Posted: 02:52am 08 Jul 2016 |
You were right - as usual, I had them backwards.
Worked perfectly after that until I tried this
[code]
TEXT 5,2,"TOO CLOSE",lm,8,1,RGB(red) [/code]
As far as I understand the manual that "should" have put the TEXT starting on the 5th LED from the left and the 2nd LED from the top?
Or have I understood it wrong?
EDIT:
I just noticed my display is upside down - the two connectors on the back, looking at the back the one on the left should be the interface to the Micromite which mine is
but the display is upside down?
I also noticed my pinout is NOT the one I posted, it has U2 instead of B2
I wonder if that is making a difference?
I flipped the display over on the short side (vertically) and the display seems to be upside dowm, or is this correct?