Guru
Joined: 02/02/2017
Location: AustraliaPosts: 1432
| Posted: 11:54am 05 Nov 2018 |
I bought 2 boards from Madness and intend to run one via my Arduino plus IR2184 drivers board combo as seen in recently here. The other is a spare, for when my desoldering skills render the board completely munted.
I want to see the difference in MOSFET gate signals between totem pole drive and gate drive IC.
I will probably use the traditional code (50Hz squarewave on one 1/2 bridge & 20kHz SPWM on the other) first, then move to the 2x sinewave code.
You will enjoy a lot of support from here if you build a system based on the EG8010.
No board level changes are needed (on the power board) for the Arduino to work.
You will need to make an interface board (taking Arduino 5V signals and driving the 2 1/2 bridges of the power board). I can help you with this if needed.
wronger than a phone book full of wrong phone numbers