Guru
Joined: 07/11/2007
Location: AustraliaPosts: 1904
| Posted: 12:24am 23 Oct 2017 |
Now that is interesting.
With my dual stack toroid I used very heavy gauge cables, two in parallel, to wire up the primary and battery connections.
It blew all the Mosfets on switch on.
Tinkered with it for a while, smaller toroid, different drivers, less capacitors, you name it, but just had mixed success. Nothing I would call reliable.
I then re built the whole caboodle in the usual one long, two short heat sink configuration and it ran over 6KW.
BUT, that was with much longer cables to the battery and primary & 2 chokes, as in a rough bench top test set up.
It should not be too hard to introduce 0.01 Ohm in series, just a steel washer between the connection lugs would do I should think.
I shall try that when I connect it all up again (making a case for it presently) and see what happens.
I won't double up with the inter connection cables either this time.
Klaus