poida
 Guru
 Joined: 02/02/2017 Location: AustraliaPosts: 1432 |
Posted: 09:50pm 07 Nov 2018 |
|
|
|
Gaspo: thanks for the info. I probably wont start on STM32 now.
I use the Arduino IDE to drive the edit/compile/link process but as you may have seen, I don't use the libraries much, only when needed and when they don't bring problems.
The Arduino Due is a ARM Cortex M3 based board and I'm familiar with the hardware (programming ADC, DAC, timer and interrupt applications directly via registers and not using the Arduino libs) but when I looked at the STM32 info, it appeared to be an alien world.
I want to say again I would like to see how the code runs when you port it.
wronger than a phone book full of wrong phone numbers |