Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:24 05 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : Armmite F4 - What would expect from MEMORY commend?

Author Message
Andrew_G
Guru

Joined: 18/10/2016
Location: Australia
Posts: 867
Posted: 02:15am 11 Apr 2021
Copy link to clipboard 
Print this post

Sorry to be such a PITA but . . .

I'm running MMBasic 5.07.00b9 on my F4. I'm porting a program that runs on a MM170 to my ArmmiteF4.
I keep getting an "Out of Memory" error on the F4.
So I checked with a MEMORY command both within the program and in Console mode.
Here is what I get with no program loaded (in fact it is just after I re-flashed it).

memory
Flash:
  0K ( 0%) Program (0 lines)
132K (100%) Free

RAM:
  0K ( 0%) 0 Variables
  0K ( 0%) General
114K (100%) Free

Wouldn't you expect more than 114k RAM free (the example in the manual shows 5470k).
(And I've tried Key 1 at power-up and two different F4 boards.)

Thanks,

Andrew
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025