Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:22 05 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : Greetings from new member

Author Message
megantara
Newbie

Joined: 25/09/2014
Location: Indonesia
Posts: 7
Posted: 07:49am 27 Sep 2014
Copy link to clipboard 
Print this post

Thank you for admitting me to this forum. Done my 1st vawt project, still under testing, gonna need to learn much more from you experienced builders.

My mill spec:

12 pole 9 coil, 6 wire out from stator for flexibility,
3 x 1mm wire 170 turns coils
1" x 2" x .5" N42
Lenz2 turbine (100cm height, 90cm diameter)Edited by megantara 2014-09-28
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025