Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:11 05 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : a view of my set-up

Author Message
Guests
Guest

Joined: 01/10/2003
Location:
Posts: 52
Posted: 01:20pm 05 Jun 2004
Copy link to clipboard 
Print this post

Hi Glenn and fellow builders

I found a couple of pic's of the way I set up the stator on a hub with a "Hundai" front wheel hub and a steering wheel drive shaft's universal joint -quite compact .those uni joints - .

The system works ,but as Glenn mentioned,you don't get enough RPM's ,unless it blows a gale.

I also re-wired the stator -both series and parallel. and in the different wire sizes.

I haven't tried to get F&P stators from local Qld. repair outlets yet ,but the going price down Syd. was a carton of vb's for the whole machine-you discard of what you don't want -a couple of machines were perfect --just highlights our "throw-away" whitegoods enviroment.
You get -stator;rotor;shaft;bearings;bearing housing;hall sensor;some good electronics and springs Etc from the bowl support system. All in all some very handy parts .
Anyhow ,enough raving , I'll try and post the Pic's.

Bruce
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025