Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 01:13 05 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : snubber calculations?

Author Message
Murphy's friend

Guru

Joined: 04/10/2019
Location: Australia
Posts: 671
Posted: 05:00am 30 Oct 2019
Copy link to clipboard 
Print this post

What would be the correct R/C values for the nanoinverter snubber?

I see the original Oztules inverter used a 56R in series with a 103 capacitor. Are these values also right for the nano (non EG8010 based) switching frequency?

There is a spreadsheet type calculator snubber calc.  on the web but I'm afraid my ancient maths are not up to using spreadsheets .

Perhaps Poida knows the answer, he generously wrote the nano's software for everybody here to share.
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025