Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 15:46 03 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : VT100 ASCII Terminal Video Signal Issue

Author Message
Vampire05
Regular Member

Joined: 06/12/2020
Location: Germany
Posts: 88
Posted: 10:18am 16 Dec 2020
Copy link to clipboard 
Print this post

Hi guys,

i need your ideas. I can not get a video signal out from my ascii terminal (vt100 emulator):









Instead of the MCP1700-330 i used the Wemos ESP32 18650 Battery Shield.
For VGA, i only connected the green signal (Pin 2) and soldered the "green" pad in the "select color" section on the pcb. I have checked connection from PIC to VGA Output-> everytbhing is fine! I testet 3 VGA Monitors but no visible Output. Same on Composite Output!

If i turn the device on, the activity led is on. On every keypress of the ps2 Keyboard the led is blinking. So i think the input part works fine.

Any Ideas of whats going on with the Video Output?

The Schematic:
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024