Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 00:31 04 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : Armmite F4 - What would expect from MEMORY commend?

Author Message
Andrew_G
Guru

Joined: 18/10/2016
Location: Australia
Posts: 840
Posted: 02:15am 11 Apr 2021
Copy link to clipboard 
Print this post

Sorry to be such a PITA but . . .

I'm running MMBasic 5.07.00b9 on my F4. I'm porting a program that runs on a MM170 to my ArmmiteF4.
I keep getting an "Out of Memory" error on the F4.
So I checked with a MEMORY command both within the program and in Console mode.
Here is what I get with no program loaded (in fact it is just after I re-flashed it).

memory
Flash:
  0K ( 0%) Program (0 lines)
132K (100%) Free

RAM:
  0K ( 0%) 0 Variables
  0K ( 0%) General
114K (100%) Free

Wouldn't you expect more than 114k RAM free (the example in the manual shows 5470k).
(And I've tried Key 1 at power-up and two different F4 boards.)

Thanks,

Andrew
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024