 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Guest Book : Micromite and the ESP8266
| Author | Message | ||||
Gizmo Admin Group  Joined: 05/06/2004 Location: AustraliaPosts: 5019 |
I seam to be going through a phase where every module I buy doesn't work as the instructions say they should.... Latest case, a ESP8266 from this Ebay link, and following the instructions on this page. I dont get past the "Hooking it up" stage, it wont respond to the AT commands. I've checked the serial data is going in with my cro, but get no response. The power LED is let. Am I supposed to flash it first, or not? The several pages I've found using the chip make no mention of it, and I get the impression they are ready to go out of the box. Glenn. The best time to plant a tree was twenty years ago, the second best time is right now. JAQ |
||||
 Print this page |
