Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 06:18 02 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Guest Book : PicoMite  ILI9431  Error Message SDCard already configured

Author Message
mikebill
Newbie

Joined: 18/01/2022
Location: United Kingdom
Posts: 4
Posted: 05:51pm 19 Jan 2022
Copy link to clipboard 
Print this post

Apologies if already covered.  My first post, first proper use of Pico.

I have PicoMite running MMBasic 5.07.03

ILI9431 display as per manual page 48, connected as per page 48.

Whatever I try to download I get error message; 'SDCard already configured'

Any suggestions as to what I'm doing wrong.

Many thanks
 
flasherror
Senior Member

Joined: 07/01/2019
Location: United States
Posts: 159
Posted: 07:36pm 19 Jan 2022
Copy link to clipboard 
Print this post

What does OPTION LIST display?
Also, "try to download" - what are you doing?
 
mikebill
Newbie

Joined: 18/01/2022
Location: United Kingdom
Posts: 4
Posted: 08:02pm 19 Jan 2022
Copy link to clipboard 
Print this post

Hi,

OPTION LIST gives OPTION SYSTEM SPI GP18,GP19,GP16

By 'try to download'  I mean F2

Thanks
 
flasherror
Senior Member

Joined: 07/01/2019
Location: United States
Posts: 159
Posted: 08:29pm 19 Jan 2022
Copy link to clipboard 
Print this post

  mikebill said  Hi,
OPTION LIST gives OPTION SYSTEM SPI GP18,GP19,GP16
By 'try to download'  I mean F2


If you've connected display as shown on P48 then it looks like you have only entered the 1st OPTION config statement?
You need to enter:
OPTION SYSTEM SPI GP18, GP19, GP16
OPTION SDCARD GP22
OPTION LCDPANEL ILI9341, L, GP15, GP14, GP13
OPTION TOUCH GP12, GP11
one at a time. Note Pico will reset after each OPTION command and you may need to reconnect your terminal program (see top of P49) to continue.

Since you've already entered OPTION SYSTEM, enter the remaining OPTION statements starting with OPTION SDCARD as listed above or on P48.
Edited 2022-01-20 06:33 by flasherror
 
mikebill
Newbie

Joined: 18/01/2022
Location: United Kingdom
Posts: 4
Posted: 09:29pm 19 Jan 2022
Copy link to clipboard 
Print this post

Many thanks.

Will start again tomorrow and report back.
 
mikebill
Newbie

Joined: 18/01/2022
Location: United Kingdom
Posts: 4
Posted: 01:51pm 20 Jan 2022
Copy link to clipboard 
Print this post

Many thanks.  All working as expected.  The 'one at a time' was the key.
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024