Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 04:32 03 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : EV's : Hall sensors on the washing machine motor

Author Message
Serheibrest
Newbie

Joined: 16/02/2019
Location: Belarus
Posts: 4
Posted: 09:23am 16 Feb 2019
Copy link to clipboard 
Print this post

Hello everyone.
I want to make a potter's wheel. Motor is from the washing machine direct drive. I think this is progressive.
I have rewired the windings, the motor is running and the powerful torque makes me happy. But not completely. Because without halls, my controller does not work correctly. And the torque can be more with halls. How to place these hall sensors, I do not know.

Therefore, I ask for help. If possible, explain the principle of the installation of sensors. I know a little theoretically that the halls should be installed at the beginning of each phase.
Winding from here Winding from here
my configuration 36Pole 6X2C
Please, show me in the picture where to put these three halls!



This topic is a duplicate, it must be removed. Why it happened I do not know.
Please forgive me)))Edited by Serheibrest 2019-02-18
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025