Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 15:21 02 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : EV's : Pmw speed controller and separate for/Rev switch wiring

Author Message
irishron40
Senior Member

Joined: 22/09/2014
Location: Ireland
Posts: 254
Posted: 02:41am 29 Aug 2024
Copy link to clipboard 
Print this post

Hello Everyone.

I had a forward/reverse switch operating my 24volt 10A Dc motor.
I had it wired with 4 relays .

Now I want to add a pmw speed controller
Which has 4 connections.

2 for power in and 2  to the motor

I am just not sure about the wiring seeing I am using the relays.

He reason for relays is that my box in which switches and pmw controller are fitted in is about one meter from motor and battery.

So power has to travel through 2X one meter.


Any help appreciated

Ron
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025