TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 07:08 19 Oct 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : EV's : I built a new E-Trike

Author

Message

Quazee137

Guru

Joined: 07/08/2016
Location: United States
Posts: 599

Posted: 01:49pm 17 Oct 2025

Copy link to clipboard

Print this post

I built a new E-Trike as I flipped my old one. Had replaced 12 year old controller
that just stopped working. I had what I though was the same but later it found out some
parts where not installed. As I was testing I hit the guide rail for gate and was shot
over the speed bump and ended up breaking my right shoulder in two places along with
two ribs and my right hand. When I was well enough I found that the ground for the
throttle had come off inside the controller sending full speed.

This time I have added a resistor between controller +5 and throttle +5. I now limit
max speed to 18MPH. Also added a small cap to the throttle out so it stopped jumping
on startup. Working on a micro to set the speed curve.

Now the pas. How can I reduce the lowest speed? It goes way to fast for me.
I haven't found and circuits showing the internal working so I could make a mod.

I just turned 70 and need things to go slow.

Thank for any help.
Quazee137

Print this page

To reply to this topic, you need to log in.