Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:46 11 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : The PIC32MZ board from OLIMEX

     Page 2 of 2    
Author Message
WhiteWizzard
Guru

Joined: 05/04/2013
Location: United Kingdom
Posts: 2959
Posted: 05:59pm 28 Feb 2018
Copy link to clipboard 
Print this post

Here is another early prototype of the MMX144 module!

This one used a very minimalistic LQFP BoB, an E64 PCB (for the power supply), one of Grogster's SD Modules, and a jumper-lead linked VGA lead.

Note on this Break-Out-Board that it was simply an LQFP PCB - I had to solder the decouplers and other minimum components - seen on the right hand side of the photo if you look very closely!

I then added a NunChuck PCB/Module I had lying around (not seen in this photo)


Edited by WhiteWizzard 2018-03-02
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025