 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : E-Bike
| Author | Message | ||||
Quazee137 Guru  Joined: 07/08/2016 Location: United StatesPosts: 600 |
I finely got my Three wheel bike converted. Front wheel 48V 1000W motor and 48v20Ah Lithium LiFePO4 Battery Pack. I got a 5" backup display and camera. Much easier than looking over my shoulder at whats coming at me from behind. The display has two composite input. So the questions are can using the duinomite-mini with a 5" touch digitizer and a XPT2046 off a bad 2.8" display work with the DuinoMite MMBasic Version 4.5? Here is the parts I am using. well I can't get the images to load.  so trying this 2018-05-15_192519_E-Bike.zip The bike has run 10 hours and the battery is at 51.20 volts. So I can get about a weeks worth of travel per charge. Glad I went with the LiFePO4. Thanks for any ideas on this. Quazee I got the DuinoMite-mini. Sad it turn out not as expected.  But very happy got me here and using MMBasic. |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
