TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 01:45 12 Nov 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM Programmer/Debugger 1C...

Page 2 of 2

Author

Message

paceman
Guru

Joined: 07/10/2011
Location: Australia
Posts: 1329

Posted: 11:01am 23 Jul 2018

Copy link to clipboard

Print this post

Oops, sorry Grogs/Azure - dead right, that's what happens when you're not concentrating.

Greg

erbp
Senior Member

Joined: 03/05/2016
Location: Australia
Posts: 195

Posted: 09:43am 21 Oct 2018

Copy link to clipboard

Print this post

@Grogs: did this project ever progress any further? I don't see these listed on your website. I would very much like to get hold of one, either 1C or 1C2 design, preferably as a completed module, but a kit would be OK if no modules available.

Can you please advise if you still plan to sell these?

Thanks,
Phil.

Grogster

Admin Group

Joined: 31/12/2012
Location: New Zealand
Posts: 9753

Posted: 12:27am 22 Oct 2018

Copy link to clipboard

Print this post

Hello, and thank you for your continued interest.

Yes, I did produce the first prototype, and it worked fine.

I must have forgotten to update this thread or something - several things going on at once, and my little brain sometimes farts.

I will PROBABLY sell these as a complete assembled and tested unit, A-la the E28 module. Being small and quite cheap - even assembled - it is probably not worth the time required to build up kits.

Do other members have any thoughts on that? IE: Just sell the assembled module, or would you like kits too? The price difference between a kit and an assembled module would probably make the kits uneconomic to produce if you see what I am getting at...

EDIT: Talk about brain fart! I just see on page one of this thread, where I had posted the photos.

Oh well - now you have two sets of photos. This is still the 1C not the 1C2. I might have made the changes, and then never got the new version PCB's made cos I forgot about it. Thanks for the prod. I will get some of the new 1C2 version in my next PCB order.Edited by Grogster 2018-10-23

Smoke makes things work. When the smoke gets out, it stops!

Page 2 of 2

Print this page

To reply to this topic, you need to log in.