Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 00:28 12 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : New case for Pi-cromite

Author Message
MikeO
Senior Member

Joined: 11/09/2011
Location: Australia
Posts: 275
Posted: 09:32am 21 Sep 2018
Copy link to clipboard 
Print this post

Hi all , I remixed a new case for a Pi-cromite project I was working on. The original case is shown here but it was using a Rasp Pi v1 and a two line LCD, Rasp Pi Music Player

My remix will take the later RPI versions and a 2.4" SPI LCD. If anyone is interested I will post the STLs just need to clean them up a little.







Codenquilts
 
PicFan
Senior Member

Joined: 18/03/2014
Location: Austria
Posts: 133
Posted: 11:16am 21 Sep 2018
Copy link to clipboard 
Print this post

Hello @mike,

Very nice housing, which material and Printer did you use? PLA?

Edited by PicFan 2018-09-22
 
MikeO
Senior Member

Joined: 11/09/2011
Location: Australia
Posts: 275
Posted: 05:08am 22 Sep 2018
Copy link to clipboard 
Print this post

I use PLA and a Geeetech I3 B
Codenquilts
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025