 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : MM+ Manual missing data...
| Author | Message | ||||
Grogster Admin Group  Joined: 31/12/2012 Location: New ZealandPosts: 9755 |
Hi. Manual and firmware version 5.05.01(latest as of this date), talks about GUI GUAGE and GUI BARGUAGE, but the commands are NOT listed in the COMMANDS section of the manual.  It took ages to find that they were detailed in the manual on pages 32 and 33, but not listed in the 'Detailed listing' of the commands. Please can the advanced manual be updated to show the new commands. Smoke makes things work. When the smoke gets out, it stops! |
||||
Geoffg Guru  Joined: 06/06/2011 Location: AustraliaPosts: 3308 |
Thanks, I will fix it in the new release. Geoff Graham - http://geoffg.net |
||||
twofingers Guru Joined: 02/06/2014 Location: GermanyPosts: 1672 |
... or GUI GAUGE and GUI BARGAUGE?  causality ≠ correlation ≠ coincidence |
||||
Turbo46 Guru Joined: 24/12/2017 Location: AustraliaPosts: 1646 |
Deja vu all over again. See this Bill Keep safe. Live long and prosper. |
||||
| Grogster Admin Group Joined: 31/12/2012 Location: New ZealandPosts: 9755 |
@ twofingers - Danke. I stand corrected. My mistake on the spelling there. Smoke makes things work. When the smoke gets out, it stops! |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
