Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 10:45 13 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Pic32prog Error code: -1

Author Message
Greg Fordyce
Senior Member

Joined: 16/09/2011
Location: United Kingdom
Posts: 153
Posted: 10:18pm 27 Oct 2019
Copy link to clipboard 
Print this post

I am trying to update an E100 Version 1D board using MMFlash. I keep getting the same error, not sure what I am doing wrong. The board has a pic16f1454.

Programming slave device
-d ascii:COM3 "D:\Downloads\Micromite_Firmware\Micromite_Plus_V5.05.02.hex"
Programmer for Microchip PIC32 microcontrollers, Version 2.0.220
   Copyright: (C) 2011-2015 Serge Vakulenko
      (ascii ICSP coded by Robert Rozee)

     Adapter: ::::::::::::::::::::
Error code: -1
Programming completed in 10.532 seconds


Greg
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2971
Posted: 10:27pm 27 Oct 2019
Copy link to clipboard 
Print this post

Hi Greg,

Have you put the pic16 into PROGRAM mode? (Momentarily short the 2 pin header and the led should light)

Regards,

Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
Greg Fordyce
Senior Member

Joined: 16/09/2011
Location: United Kingdom
Posts: 153
Posted: 10:29pm 27 Oct 2019
Copy link to clipboard 
Print this post

Cheers Mick,

That's done it, the E100 has a button marked select just for this!

Greg
 
Grogster

Admin Group

Joined: 31/12/2012
Location: New Zealand
Posts: 9755
Posted: 11:14pm 27 Oct 2019
Copy link to clipboard 
Print this post

Smoke makes things work. When the smoke gets out, it stops!
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2971
Posted: 03:07am 28 Oct 2019
Copy link to clipboard 
Print this post

  Greg Fordyce said  Cheers Mick,

That's done it, the E100 has a button marked select just for this!

Greg


GDay Greg,

Great news..

Glad I am not totally useless.\\

Kind Regards,

Mick
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025