TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 17:38 14 Nov 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : CMM2 OPTION RTC DRIVE LOW. Losing Time.

Author

Message

Chopperp

Guru

Joined: 03/01/2018
Location: Australia
Posts: 1106

Posted: 07:20am 30 Aug 2020

Copy link to clipboard

Print this post

Hi,

I've noticed my CMM2 losing quite a bit of time lately when sitting at idle.

TIME$ gets updated from a GPS timestamp when my test program is up & running so not a problem until I stop for a bit. It relies on a reasonably accurate time to start properly. It was OK a week or so ago.

I did an OPTION LIST & found OPTION RTC DRIVE LOW which I can't get rid of or change. I wanted to change it to see what happens to the timing.

OPTION RTC CALIBRATE didn't improve matters much (running matherp's time test from a while ago)

Can't find any reference to it in the Manual.

Brian.

ChopperP

matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 10580

Posted: 07:24am 30 Aug 2020

Copy link to clipboard

Print this post

Your options have somehow got corrupted. Use OPTION RESET and then redo your normal settings

Chopperp

Guru

Joined: 03/01/2018
Location: Australia
Posts: 1106

Posted: 07:33am 30 Aug 2020

Copy link to clipboard

Print this post

Thanks Peter

It was losing 3 seconds every 4 minutes.
Now much much better
Now to do the calibrate again

Brian

ChopperP

Print this page

To reply to this topic, you need to log in.