TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 01:47 17 Nov 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Counting Pin

Author

Message

palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 2006

Posted: 10:59pm 28 Dec 2020

Copy link to clipboard

Print this post

I have a pin set to CIN, how can I set an initial value for the pin. I have tried Pin(15)=number but it doesn't work. I am trying to save the value of the pin and then reinstate it later.

"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"

Turbo46

Guru

Joined: 24/12/2017
Location: Australia
Posts: 1646

Posted: 11:17pm 28 Dec 2020

Copy link to clipboard

Print this post

I don't think you can set it to a particular value. You can set it to zero by issuing the SETPIN command again though. Can you use a variable as an offset and add the count from the pin to another variable.

Bill

Keep safe. Live long and prosper.

palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 2006

Posted: 11:25pm 28 Dec 2020

Copy link to clipboard

Print this post

Yes, that is what I was doing but I was changing a few things and thought I would save the Pin value. I'll revert to the old way. Thanks.

"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"

Print this page

To reply to this topic, you need to log in.