Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:24 21 Nov 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Mac for Programming PicoMite

Author Message
Mark
Regular Member

Joined: 26/11/2022
Location: United States
Posts: 85
Posted: 11:58pm 10 Feb 2023
Copy link to clipboard 
Print this post

If anyone is using a Mac for programming the PicoMite, I have created a Mac Terminal setup (attached) that in conjunction with Minicom improves the interface to the PicoMite including the built-in editor. Most of the editor navigation keys work, the only one I couldn't figure out was INS, so I have to use ^N. The terminal also supports some of the high (> 128) characters so you can draw boxes on the screen.

I use the command line below to start Minicom


minicom -c on -L -b 115200 -D <your device>


I hope this helps you. I welcome any comments.
MMBasic.terminal.zip
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025