 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Olimex Pic32 T795H
| Author | Message | ||||
IanRogers Senior Member  Joined: 09/12/2022 Location: United KingdomPosts: 152 |
Is there a version of MM basic I could use on this beasty It's sat doing nothing next to a spare VGA monitor. Could any of the software's available work ( being very limited pins ) I'd give my left arm to be ambidextrous |
||||
| JohnS Guru  Joined: 18/11/2011 Location: United KingdomPosts: 4148 |
I can only find the T795. What's the H variant? The T795 can run Duinomite Basic which was derived from MMBasic. Also, Geoff's site may have a version of MMBasic that will run. edit: found a pinout so I guess start checking what PIC32 (795) MMBasic wants and whether there's anything bad. The Maximite version might be worth a look. John Edited 2023-03-03 22:51 by JohnS |
||||
| IanRogers Senior Member Joined: 09/12/2022 Location: United KingdomPosts: 152 |
I was basing it on the UBW32 ( bitwhacker ) but that sports a 100pin device.. Same as the CMM and CMM2 but this has many many pins missing... In fact no portA and only a few PORTG and PORTF pins. I already have two Maximites running.. I wanted to connect it to my spare VGA monitor I'd give my left arm to be ambidextrous |
||||
| JohnS Guru Joined: 18/11/2011 Location: United KingdomPosts: 4148 |
CMM2 is a very different CPU chip! Maximite is same 64-pin 795, I believe. CMM may be too, but I never used one. Don't try to use 100-pin PIC32 MMBasic on 64-pin PIC32. John Edited 2023-03-04 03:38 by JohnS |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
