TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 01:54 23 Nov 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : PWM problem on Picomite

Author

Message

circuit
Senior Member

Joined: 10/01/2016
Location: United Kingdom
Posts: 293

Posted: 11:09am 20 Dec 2023

Copy link to clipboard

Print this post

SETPIN GP10, PWM5A
PWM 5,100,30

Works just fine. However...

SETPIN GP1, PWM0B
PWM 0,100,30
Error : Pin not set for PWM

Am I reading the manual incorrectly or is there another issue?

(Picomite 5.080005)

phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2837

Posted: 11:18am 20 Dec 2023

Copy link to clipboard

Print this post

Nearly everyone get caught with this. For channel B you must leave a placeholder for A.
SETPIN GP1, PWM0B
PWM 0,100, ,30
Edited 2023-12-20 21:22 by phil99

circuit
Senior Member

Joined: 10/01/2016
Location: United Kingdom
Posts: 293

Posted: 11:45am 20 Dec 2023

Copy link to clipboard

Print this post

phil99 said Nearly everyone get caught with this. For channel B you must leave a placeholder for A.
SETPIN GP1, PWM0B
PWM 0,100, ,30

Thank you... you are most generous in excusing me with "nearly everyone gets caught with this" but the truth is that I was not paying proper attention to the instructions. Anyway, all is now operational and I appreciate the speed of your reply.

Print this page

To reply to this topic, you need to log in.