TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 09:17 16 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : 2 sine different phase

Author

Message

stanleyella

Guru

Joined: 25/06/2022
Location: United Kingdom
Posts: 2547

Posted: 06:38pm 16 Aug 2024

Copy link to clipboard

Print this post

Is it possible to generate two 100Hz sinewaves and vary the phase of one to the other without hardware? I fancy Lissajous x/y but sampling a-d.

Martin H.

Guru

Joined: 04/06/2022
Location: Germany
Posts: 1224

Posted: 06:59pm 16 Aug 2024

Copy link to clipboard

Print this post

Page 122 PicoMite User Manual

PLAY SOUND soundno,channelno, type [,frequency][,volume]
so try

Play SOUND 1,B,S,100,25
Pause 2 'try 1 to 9
Play SOUND 2,B,S,100,25

at 100 Hz you got 100 oscillations per second that means every oscillation is 10 milliseconds long. If I start the 2nd tone 2 ms late the waves should be shifted.
Edited 2024-08-17 05:04 by Martin H.

'no comment

Andy-g0poy
Regular Member

Joined: 07/03/2023
Location: United Kingdom
Posts: 75

Posted: 07:21pm 16 Aug 2024

Copy link to clipboard

Print this post

Another method of doing this, is to generate a table of all the sine amplitude values. Choose the number of samples to suit the resolution you need. (make it such that it divides easily)

Read the table at the required frequency needed and output the value to whatever I/O system you are using.

That gives you a single sinewave.

However if you also read the table twice with a specific increment then you can generate multiple sinewaves at a specific phase.

e.g.
If the table is 100 samples long, then reading from the table at position(x) and position (x+25) will give you two sinewaves 90 degree phase shift between them.

Andy

Print this page

To reply to this topic, you need to log in.