TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 20:23 12 Jul 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Red line isn't red on PicoMite VGA RP2350A Edition V6.00.01

Author

Message

andreas

Senior Member

Joined: 07/12/2020
Location: Germany
Posts: 226

Posted: 09:49pm 02 Jan 2025

Copy link to clipboard

Print this post

Hi,

I tried to draw colour lines on a PicoMite VGA RP2350A. When I do cls rgb(red) everything is red - so colour works on the hardware, but the colour within the line etc. commands is always white.

firmware is from 29.12.2024

This is the hardware

-andreas

phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2611

Posted: 10:07pm 02 Jan 2025

Copy link to clipboard

Print this post

Are you in Mode 1 (monochrome)? It works in Mode 3.

For me the surprise is CLS RGB(red) gives a red screen in Mode 1.
.
Edited 2025-01-03 08:10 by phil99

stanleyella

Guru

Joined: 25/06/2022
Location: United Kingdom
Posts: 2540

Posted: 11:32pm 02 Jan 2025

Copy link to clipboard

Print this post

I think although mode 1 is monochrome, the foreground and background colours can be any of 16. vga mode 3 colours are fine

phil99

Guru

Joined: 11/02/2018
Location: Australia
Posts: 2611

Posted: 11:37pm 02 Jan 2025

Copy link to clipboard

Print this post

Yes, I hadn't been keeping up with progress.

andreas

Senior Member

Joined: 07/12/2020
Location: Germany
Posts: 226

Posted: 07:15am 03 Jan 2025

Copy link to clipboard

Print this post

phil99 said Are you in Mode 1 (monochrome)? It works in Mode 3.

For me the surprise is CLS RGB(red) gives a red screen in Mode 1.
.

Thank you for the tip with the mode! After switching to mode 3 everything works fine!

-andreas

Print this page

To reply to this topic, you need to log in.