 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : rp2040 running CPM on HDMI screen
| Author | Message | ||||
| zeitfest Guru  Joined: 31/07/2019 Location: AustraliaPosts: 551 |
Interesting device, two rp2040s, runs CPM with HDMI screen with USB keyboard cimbo |
||||
bigmik Guru Joined: 20/06/2011 Location: AustraliaPosts: 2946 |
Hi Zeitfest, It’s interesting and I had a smile watching Zork run on it. Reading between the lines it appears to read in the 8080 code and reinterpret it into code suitable for a Pico. It was hard to tell how responsive it is as there seemed to be glitches or delays on that very short demo clip. Unfortunately, well for me, it’s come way too late. My days of cp/m are way behind me now. Regards, Mick . Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
Mixtel90 Guru Joined: 05/10/2019 Location: United KingdomPosts: 7574 |
You can probably buy a proper CP/M computer for the cost of those components now. :) XYZZY :) Mick Zilog Inside! nascom.info for Nascom & Gemini Preliminary MMBasic docs & my PCB designs |
||||
| zeitfest Guru Joined: 31/07/2019 Location: AustraliaPosts: 551 |
Yes I can't see myself using the editor soon. Looks similar to early mainframe utilities, ah, forgettable but not forgotten !!! In plughral !  |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
