TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 17:48 03 May 2025	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : setpin analog volts prob

Author

Message

sparkey

Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 819

Posted: 03:32am 24 Jun 2011

Copy link to clipboard

Print this post

when i use setpin "setpin 1,1"..then print that pin i am getting voltages from point 8 of a volt to 2point 5 volts nothing connected to i/o at all should this be so erratic ...thank you....

technicians do it with least resistance

BobDevries

Senior Member

Joined: 08/06/2011
Location: Australia
Posts: 266

Posted: 04:28am 24 Jun 2011

Copy link to clipboard

Print this post

The inputs tend to float a bit if there is no termination. Try putting a 10K resistor to ground, and see if it fixes this.

Regards,

Bob Devries
Dalby, QLD, Australia

Print this page

To reply to this topic, you need to log in.