Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 05:44 15 May 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : MM-BMP085

Author Message
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1967
Posted: 06:48pm 03 Jul 2013
Copy link to clipboard 
Print this post

I'm trying to read the values from the BMP085 temperature/pressure sensor. I am using the code posted by Olimex from Feb 2012 for the Duinomite. All I get is error messages. The sensor behaves as if it is not connected.
Does the code need changing to run on the MM.
Palcal.Edited by palcal 2013-07-05
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1967
Posted: 07:02pm 03 Jul 2013
Copy link to clipboard 
Print this post

Forget it. It helps to connect the pull up resistors.
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025