 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Questions about MICROMITE
| Author | Message | ||||
| rentner111 Newbie  Joined: 18/03/2014 Location: AustriaPosts: 19 |
Questions about MICROMITE 1 in Micromite User Manual Ver 4.5 Beta 16 is on page 24 to read under INTERRUPTS: All I/O pins can be as configured to generate to interupt using setpin command ...... The schedule of the 44-pin connections but is not the INT function for all pins possible. It also comes on this pins the error message that no Int function is possible. 2 Is it not possible to activate the pull-up function? This would save a lot of space on the layout, which is required by the now necessary pull-up resistors. With thanks for an answer |
||||
Geoffg Guru  Joined: 06/06/2011 Location: AustraliaPosts: 3269 |
Ah, ALL I/O pins is wrong (I will fix that). Only the pins marked INT can be used. Yes, some way of implementing the on chip pullups and pulldowns is on my ToDo list but it will have to wait for a later release. Geoff Geoff Graham - http://geoffg.net |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
