Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 06:08 07 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Simple Question

Author Message
samuelT
Newbie

Joined: 15/09/2014
Location: United States
Posts: 5
Posted: 03:15pm 14 Oct 2014
Copy link to clipboard 
Print this post

Hello:

I am new hear and hope you can answer some simple questions.

1) Does the micromite have the library calls to use an SD card?

2) If the MMedit is used does the internal micromite editor need to be used?

3) If i had the Microchip MPLAB-X 'C' compiler then would i get the same compiled
code as comes in a micromite reprogrammed chip?

Thanks for bring me up to speed.
cheers,
samT
 
TassyJim

Guru

Joined: 07/08/2011
Location: Australia
Posts: 6269
Posted: 05:08pm 14 Oct 2014
Copy link to clipboard 
Print this post

Welcome.

1. No the micromite does not have any code for talking to SD cards - Have you looked at the Maximite?

2. If you use MMEdit, there is no need for the inbuilt editor but I do use it for small changes to the code while testing. Reloading a long program for a simple change takes some time so it can be quicker to run the inbuilt editor.
With MMEdit, you can read the code back from the micromite into MMEdit.

3. Compiling the micromite source requires the expensive compiler, not the free one.

Jim

VK7JH
MMedit
 
samuelT
Newbie

Joined: 15/09/2014
Location: United States
Posts: 5
Posted: 05:08am 15 Oct 2014
Copy link to clipboard 
Print this post

Thanks for the info.

samT
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025