Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:25 06 Jul 2025 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Ascii VT100 Help

Author Message
micronut
Newbie

Joined: 03/09/2014
Location: United States
Posts: 37
Posted: 06:07am 25 Oct 2014
Copy link to clipboard 
Print this post

I just built the Ascii VT100. So far I've hooked up a MuP to it with no problems. When I hook up my Windows 7 laptop with Putty I get a "cannot configure Com port" error. RealTerm cannot connect either. When I use TeraTerm I get no errors but I get no response in TeraTerm and the monitor on the VT100 has a blinking cursor. When I press a key on either the laptop keyboard or the keyboard on the VT100 I get a blinking led on the board. I have both set for 38400 8N1.

Could the Windows driver be corrupt?
 
Geoffg

Guru

Joined: 06/06/2011
Location: Australia
Posts: 3282
Posted: 10:59am 25 Oct 2014
Copy link to clipboard 
Print this post

I bet that yo do not have anything echoing the characters being typed. Jumper the serial Tx and Rx pins on the VT100 board - that will echo them so that they will show up on the display.

Geoff
Geoff Graham - http://geoffg.net
 
micronut
Newbie

Joined: 03/09/2014
Location: United States
Posts: 37
Posted: 11:08am 26 Oct 2014
Copy link to clipboard 
Print this post

Thanks Geoff, that fixed it!
 
Print this page


To reply to this topic, you need to log in.

The Back Shed's forum code is written, and hosted, in Australia.
© JAQ Software 2025