 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : DMbasic 4.5 File Issue
| Author | Message | ||||
| akashh Senior Member  Joined: 19/01/2014 Location: IndiaPosts: 115 |
I have my prototype perpaid water dispenser ready and I installed the Duinomite in it. While debugging which involves removing the sd and putting it in my PC, making file changes and putting it back, I noticed that the autorun.bas and the config file were not showing as updated on dmbasic. The microSD is 8 gb and fat32 formatted. I did this a couple of times with the same result, and I am attributing this (correct me if I am wrong) to the usage of a different FAT table perhaps? Deleting the file before saving it resulted in everything working fine. Any ideas what could be the cause or if there is a fix for this? |
||||
Geoffg Guru  Joined: 06/06/2011 Location: AustraliaPosts: 3282 |
This is because the firmware did not know that the card was removed and updated. The Duinomite does not have a reliable method of detecting when the SD card is removed but I was able to incorporate a trick in MMBasic to overcome this. I forget what version this was introduced but if you upgrade to the latest version of MMBasic it should work for you. Geoff Geoff Graham - http://geoffg.net |
||||
| akashh Senior Member Joined: 19/01/2014 Location: IndiaPosts: 115 |
Geoff, thanks for the reply. However, I did power off the duinomite before removing and re-inserting the SD Card. So that would not apply, right? |
||||
 Print this page |
 |
The Back Shed's forum code is written, and hosted, in Australia. | © JAQ Software 2025 |
